Pacific Power Source ADF Series Operation Manual page 212

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Query Syntax
Description
Query Example
Query Syntax
Description
Query Example
Query Syntax
Description
Query Example
Query Syntax
Description
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
[SOURce:]PROTect:PEAK:VOLTage:LEVel <VOLTAGE LEVEL>
This command sets the maximum voltage peak level. If the output
voltage peak exceeds the programmed peak level by more than this
amount, an error is tripped.
<VOLTAGE LEVEL>
<nr2>
PROT:PEAK:VOLT:LEV 120.0
[SOURce:]PROTect:PEAK:VOLTage:LEVel?
<nr2>
PROT:PEAK:VOLT:LEV?
500.000
[SOURce:]PROTect:PEAK:VOLTage:LEVel:MINimum?
This command returns the minimum voltage peak level setting.
PROT:PEAK:VOLT:LEV:MIN?
0.000
[SOURce:]PROTect:PEAK:VOLTage:LEVel:MAXimum?
This command returns the maximum voltage peak level setting
PROT:PEAK:VOLT:LEV:MAX?
500.000
[SOURce:]PROTect:PEAK:VOLTage:LEVel:DEFault?
This command returns the default voltage peak level setting
PROT:PEAK:VOLT:LEV:DEF?
500.000
[SOURce:]PROTect:PEAK:VOLTage:TRIPped?
This command returns 1 if the voltage peak protection has been
tripped or 0 if no trip occurred.
PROT:PEAK:VOLT:TRIP?
0.000
[SOURce:]PROTect:PEAK:VOLTage:TRIPped:CLEar
This command clears the peak voltage protection trip status. Once
cleared, the power source output can be re-enabled.
<VOLTAGE LEVEL>
<nr2>
PROT:PEAK:VOLT:TRIP:CLE
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 212 of 349