Pacific Power Source ADF Series Operation Manual page 164

• IMMEDIATE
• AUTORUN
7.3.13.9 Strobe Output
The Strobe Output is used to synchronize or trigger external equipment to an event
occurring on the AC power source.
Available settings are:
TRANSIENT
•
OUTPUT STATE
•
• SOURCE
7.3.13.10 Remote Control
The remote control input is used to control operation of the output relay.
Available settings are:
• DISABLED
REMOTE INHIBIT
•
• REMOTE ENABLE
See Section 6.8.5.6.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
Rear Panel, Connectors and Protection
SECTION 7:
[ ON | OFF ] Ignore phase update setting if ON
[ ON | OFF ] No RUN command required if ON
ON = Strobe output on transient start
ON = Strobe output on relay close
ON = Strobe output on any program parameter change
No remote output control
Contact closure needed to close output relay
Contact closure or front panel can control output relay
ADF SERIES™ OPERATION MANUAL
Page 164 of 349