Pacific Power Source ADF Series Operation Manual page 232

Query Format
Description
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
SYSTem:COMMunicate:LAN:VISA?
Queries the VISA resource name / address string
<cr>
TCPIP::ADF-1003::INSTR
SYSTem:COMMunicate:LAN:APPly
Applies all changes send using the COMM:LAN commands.
None
n/a
SYST:COMM:LAN:APP
SYSTem:COMMunicate:LAN:MASK
This command sets the IP mark value for the power source LAN
interface. It is normally obtained through DCHP. If a static IP must be
used, the mask has to set as well.
ddd.ddd.ddd.ddd (four octets ranging in value from 0 to 255
representing one 16 bit unsigned integer value each.
<cr>
SYST:COMM:LAN:MASK 255.255.254.0
SYSTem:COMMunicate:LAN:MASK?
<cr>
SYST:COMM:LAN:MASK?
255.255.254.0
SYSTem:COMMunicate:LAN:DNSaddress
Sets the IP address for the DNS server
ddd.ddd.ddd.ddd (four octets ranging in value from 0 to 255
representing one 16 bit unsigned integer value each.
<cr>
SYST:COMM:LAN:DNS 132.18.21.208
SYSTem:COMMunicate:LAN:DNSaddress?
<cr>
SYST:COMM:LAN:DNS?
132.18.21.208
SYSTem:COMMunicate:LAN:GWADdress
Sets the IP address for the Network Gateway. A default gateway is
the node on the computer network that the network software uses
when an IP address does not match any other routes in the routing
table
<cr>
SYST:COMM:LAN:GWAD 132.18.21.254
SYSTem:COMMunicate:LAN:GWADdress?
<cr>
SYST:COMM:LAN:GWAD?
132.18.21.254
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 232 of 349