Calibration Commands; Adf Calibration Commands - Pacific Power Source ADF Series Operation Manual

8.3 Calibration Commands

Calibration commands allow for fully automated calibration of the power source.
Note: It is not recommended for the end user to use these command unless calibration
must be automated. Any errors in using these commands could invalidate user
calibration data. Pacific Power Source recommends the use of a competent and
authorized calibration lab to perform routine calibration.
The following calibration commands are supported. Commands marked "UPC" are provided
for backward compatibility with UPC controller based PPS power sources.
8.3.1

ADF Calibration Commands

Command Syntax
Description
Parameters
Parameter Format
Example
Command Syntax
Description
Parameters
Parameter Format
Example
Command Syntax
Description
Parameters
Parameter Format
Example
Command Syntax
Description
Parameters
Parameter Format
Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
CALibrate:COEFFicients:OFFSET:VOLTage
Calibrates output DC voltage offset to lowest possible level.
None
n/a
CAL:OFFSET:VOLT
CALibrate:COEFFicients:OFFSET:CURRent
Calibrates output DC current offset to lowest possible level
None
n/a
CAL:OFFSET:CURR
CALibrate:COEFFicients:NOISE:VOLTage
Calibrates output voltage noise to lowest possible level.
None
n/a
n/a
CALibrate:COEFFicients:NOISE:CURRent
Calibrates output current noise to lowest possible level.
None
n/a
n/a
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 169 of 349