Pacific Power Source ADF Series Operation Manual page 209

Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example
Command Syntax
Description
Parameters
Parameter Format
Example
Query Format
Returned Data Format
Query Example

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
[SOURce:]CURRent:LIMit:AUTO
This commands enables or disables the Auto Current Limit function.
This function automatically adjusts the programmed current limit
level as a function of programmed voltage along the constant power
curve of the voltage range.
For example: On a 3150ADF model in three phase mode, if VOLT = 0
and CURR:LIM = 41.67 and voltage is changed to V = 300, the
CURR:LIM will change to: 5000 VA / 300 Vac = 16.0.
If CURR:LIM:AUTO = OFF then the CURR:LIM setting will remain at
41.67A and the power source will power limit at 5000VA instead if
the load draws more than 16Aac.
< 0 | OFF | 1 | ON >
<b>
CURR:LIM:AUTO ON
[SOURce:]CURRent:LIMit:AUTO?
<b>
CURR:LIM:AUTO?
1
[SOURce:]CURRent:OVerload
This command turns the overload current mode on or off
[ 0 | OFF | 1 | ON ]
<b>
SOUR:CURR:OV ON
[SOURce:]CURRent:OVerload?
<b>
CURR:OV?
1
ADF SERIES™ OPERATION MANUAL
Remote Control Programming
SECTION 8:
Page 209 of 349