Sound Levels - Pacific Power Source ADF Series Operation Manual

5.10 Sound Levels

Sound pressure level from power source may exceed 85 dBA.
Sound pressure level should be measured both at the operator's
position in normal use and at whatever point 1 meter from the
power source enclosure that has the highest sound pressure level.
The installer shall provide measures to reduce the sound pressure
level at the operator's point of use to a safe level. These measures
may include the fitting of noise-reducing baffles or hoods or
provision of protective earpieces.
Le niveau sonore de l´appareil peut dépasser 85 dBA.
Le niveau sonore doit être mesuré à la fois à la position de
l´opérateur en utilisation normale et quelque soit le point à 1 mètre
de l´enceinte de l´appareil qui a le niveau sonore le plus élevé.
L´installateur doit prendre des mesures visant à réduire le niveau
sonore au point d´utilisation de l´opérateur. Ces mesures peuvent
inclure la mise en place de hottes antibruit, our la fourniture
d´oreillettes de protection.
When the equipment is operated at or near full rated output power, fan speed will be at its
highest and corresponding noise levels will be higher. Operators should wear ear protection
while exposed to these levels of sound.

Entire Contents Copyright 2018 by Pacific Power Source, Inc. (PPS) • All Rights Reserved • No reproduction without written authorization from PPS.
ADF Series Power Source Operation Manual
WARNING
AVERTISSEMENT
ADF SERIES® OPERATION MANUAL
SECTION 5: UNPACKING AND INSTALLATION
Page 48 of 349