Show Lan Status And Statistics - Digi IX10 User Manual

Interfaces
(config network interface my_lan)> ipv6 dhcpv6_server ?
DHCPv6 server: The DHCPv6 server settings for this network interface.
Parameters
-----------------------------------------------------------------------
--------
enable
(config network interface my_lan)>
d. Modify any of the remaining default settings as appropriate.
8. Save the configuration and apply the change:
(config network interface my_lan)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show LAN status and statistics


WebUI
1. Log into the IX10 WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.

Command line
1. Log into the IX10 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network
> show network
Interface
----------------
defaultip
defaultlinklocal
eth1
eth1
eth
eth
loopback
IX10 User Guide
Current Value
true
command at the Admin CLI prompt:
Proto Status Address
----- ------- -------------------------------
IPv4 up 192.168.210.1/24
IPv4 up 169.254.100.100/16
IPv4 up 10.10.10.10/24
IPv6 up fe00:2404::240:f4ff:fe80:120/64
IPv4 up 192.168.2.1/24
IPv6 up fd00:2704::1/48
IPv4 up 127.0.0.1/8
Local Area Networks (LANs)
Enable
89