Manage Elements In Lists - Digi IX10 User Manual

Command line interface
4. Type zone to move to the zone node:
(config service ssh acl)> zone
(config service ssh acl zone)>
You can also enter multiple nodes at once to move multiple steps in the configuration:
(config)> service ssh acl zone
(config service ssh acl zone)>
Move backward one node in the configuration by entering two periods (..):
n
(config service ssh acl zone)> ..
(config service ssh acl)>
You can also move back multiples nodes in the configuration by typing multiple sets of two
periods:
(config service ssh acl zone)> .. .. ..
(config service)>
Move to the root of the config prompt from anywhere within the configuration by entering
n
three periods (...):
(config service ssh acl zone)> ...
(config)>

Manage elements in lists

While in configuration mode, you can use the add, del, and move action commands to manage
elements in a list. When working with lists, these actions require an index number to identify the list
item that will be acted on.
Add elements to a list
When used with parameters that contains lists of elements, the add command is used to add an
element to the list.
For example, to add an authentication method:
1. Display current authentication method by using the show command:
(config)> show auth method
0 local
(config)>
2. Add an authentication method by using the add index_item command. For example:
To add the TACACS+ authentication method to the beginning of the list, use the index
n
number 0:
(config)> add auth method 0 tacacs+
(config)> show auth method
0 tacacs+
IX10 User Guide
Configuration mode
581