Digi IX10 User Manual page 265

Services
To limit access to hosts connected through a specified interface on the IX10 device:
n
(config)> add service web_admin acl interface end value
(config)>
Where value is an interface defined on your device.
Repeat this step to list additional interfaces.
To limit access based on firewall zones:
n
(config)> add service web_admin acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Repeat this step to list additional firewall zones.
4. (Optional) If you have your own signed SSL certificate, if you have your own signed SSL
certificate, set the certificate and private key by pasting their contents into the service web_
admin cert command. Enclose the certificate and private key contents in quotes (").
(config)> service web_admin cert "ssl-cert-and-private-key"
(config)>
If SSL certificate is blank, the device will use an automatically-generated, self-signed
n
certificate.
The SSL certificate and private key must be in PEM format.
n
IX10 User Guide
Display a list of available interfaces:
Use ... network interface ? to display interface information:
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
---------------------------------------------------------
----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Configure the web administration service
265