Digi IX10 User Manual page 42

Interfaces
If the type of probe test is:
n
Ping: Configure the number of bytes in the ping packet.
l
Interface status: Configure the amount of time that the interface is down before it is
l
considered to have failed, and the amount of time it takes to make an initial connection
before it is considered down.
Additional test targets.
n
If more than one test target is configured, determine whether the interface should fail over
n
based on the failure of one of the test targets, or all of the test targets.
To configure the IX10 device to regularly probe connections through the WWAN:

WebUI
SureLink can be configured for both IPv4 and IPv6.
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Create a new WWAN or select an existing one:
To create a new WWAN, see
n
To edit an existing WWAN, click to expand the appropriate WWAN.
n
5. After creating or selecting the WWAN, click IPv4 (or IPv6) > SureLink.
6. Enable SureLink.
SureLink can be enabled for both IPv4 and IPv6 configurations. By default, SureLink is enabled
for IPv4 for the preconfigured WWAN (Modem). It is disabled for IPv6.
7. Click to expand Test targets.
8. For Add Test Target, click .
IX10 User Guide
Wireless Wide Area Networks (WWANs)
Configure a Wireless Wide Area Network (WWAN).
42