Digi IX10 User Manual page 104

Interfaces

WebUI
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Click to expand an existing LAN, or create a new LAN. See
5. Disable the DHCP server, if it is enabled:
a. Click to expand IPv4 > DHCP server.
b. Click Enable to toggle off the DHCP server.
6. Click to expand DHCP relay.
7. For Add DHCP Server:, click .
8. For DHCP server address, type the IP address of the relay server.
9. Repeat for each additional DHCP relay server.
10. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX10 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Add a DHCP relay server to an existing LAN. For example, to add a server to a LAN named my_
lan:
(config)> add network interface my_lan ipv4 dhcp_relay end
(config network interface lan1 my_lan dhcp_relay 0)>
See Configure a LAN
IX10 User Guide
for information about creating a LAN.
Local Area Networks (LANs)
Configure a LAN.
104