Routing Services - Digi IX10 User Manual

Routing
where value uses the format IPv4_address[/netmask], or any to match any IPv4
address.
address6: Matches the destination IPv6 address to the specified IP address or network.
n
Set the address that will be matched:
(config network route policy 0)> dst address6 value
(config network route policy 0)>
where value uses the format IPv6_address[/prefix_length], or any to match any IPv6
address.
mac: Matches the destination MAC address to the specified MAC address. Set the MAC
n
address to be matched:
(config network route policy 0)> dst mac MAC_address
(config network route policy 0)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Routing services

Your IX10 includes support for dynamic routing services and protocols. The following routing services
are supported:
Service or
protocol
RIP
RIPng
OSPFv2
OSPFv3
BGP
Babel
IS-IS
IX10 User Guide
Information
The IPv4 Routing Information Protocol (RIP) service supports RIPv2 (
RFC1058
and RIPv1 ( ).
The IPv6 Routing Information Protocol (RIP) service supports RIPng (
The IPv4 Open Shortest Path First (OSPF) service supports OSPFv2 (
The IPv6 Open Shortest Path First (OSPF) service supports OSPFv3 (
The Border Gateway Protocol (BGP) service supports BGP-4 (
The IPv4 and IPv6 Babel service.
The IPv4 and IPv6 Intermediate System to Intermediate System (IS-IS) service.
IP routing
RFC2453
)
RFC2080
).
RFC2328
).
RFC2740
).
RFC1771
).
135