Digi IX10 User Manual page 62

Interfaces
9. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX10 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. At the config prompt, type:
(config)> network interface modem modem apn 0 apn value
(config)>
where value is the APN for the SIM card.
4. (Optional) To add additional APNs:
a. Use the add command to add a new APN entry. For example:
(config)> add network interface modem modem apn end
(config network interface modem modem apn 1)>
b. Set the value of the APN:
(config network interface modem modem apn 1)> apn value
(config network interface modem modem apn 1)>
where value is the APN for the SIM card.
5. (Optional) Set the IP version:
(config)> network interface modem modem apn 0 ip_version version
(config)>
where version is one of the following:
IX10 User Guide
Wireless Wide Area Networks (WWANs)
62