Download Mibs - Digi IX10 User Manual

Services
(config)> service snmp mdns enable true
(config>
9. (Optional) Set the authentication type. Allowed values are MD5 or SHA. The default is MD5.
(config)> service snmp auth_type SHA
(config)>
10. (Optional) Set the privacy passphrase. If not set, the password, entered above, is used.
(config)> service snmp privacy pwd
(config)>
11. (Optional) Set the privacy protocol, either DES or AES. The default is DES.
(config)> service snmp privacy_protocol AES
(config)>
12. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
13. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Download MIBs

This procedure is available from the WebUI only.
Required configuration items
Enable SNMP.
n
To download a .zip archive of the SNMP MIBs supported by this device:

WebUI
1. Log into the IX10 WebUI as a user with Admin access.
2. Enable SNMP.
See Configure Simple Network Management Protocol (SNMP)
and configuring SNMP support on the IX10 device.
3. On the main menu, click Status. Under Services, click SNMP.
IX10 User Guide
Simple Network Management Protocol (SNMP)
for information about enabling
291