Change The Access Rights For A Predefined Group - Digi IX10 User Manual

User authentication

Change the access rights for a predefined group

By default, two authentication groups are predefined: admin and serial. To change the access rights
of the predefined groups:

WebUI
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > Groups.
4. Click the authentication group to be changed, either admin or serial, to expand its
configuration node.
5. Click the box next to the following options, as appropriate, to enable or disable access rights
for each:
Admin access
n
For groups assigned Admin access, you can also determine whether the Access level
should be Full access or Read-only access.
l
l
The default is Full access.
Interactive shell access
n
Shell access is not available if the Allow shell parameter has been disabled. See
shell access
Serial access
n
IX10 User Guide
Full access provides users of this group with the ability to manage the IX10 device
by using the WebUI or the Admin CLI.
Read-only access provides users of this group with read-only access to the WebUI
and Admin CLI.
for more information about the Allow shell parameter.
Authentication groups
Disable
377