Digi IX10 User Manual page 46

Interfaces
a. Move back two levels in the configuration by typing .. ..:
(config network interface my_wwan ipv4 surelink target 0)> .. ..
(config network interface my_wwan ipv4 surelink>
b. To configure the device to restart the interface when its connection is considered to have
failed:
(config network interface my_wwan ipv4 surelink)> restart enable
(config network interface my_wwan ipv4 surelink>
This is useful for interfaces that may regain connectivity after restarting, such as a cellular
modem.
c. To configure the device to reboot when the interface is considered to have failed:
(config network interface my_wwan ipv4 surelink)> reboot enable
(config network interface my_wwan ipv4 surelink>
Note If both the restart and reboot parameters are enabled, the reboot parameter takes
precedence.
d. Set the Interval between connectivity tests:
(config network interface my_wwan ipv4 surelink)> interval value
(config network interface my_wwan ipv4 surelink>
The default is 15 minutes.
e. If more than one test target is configured, determine whether the interface should fail
over based on the failure of one of the test targets, or all of the test targets:
(config network interface my_wwan ipv4 surelink)> success_condition
value
(config network interface my_wwan ipv4 surelink>
Where value is either one or all.
f. Set the number of probe attempts before the WAN is considered to have failed:
(config network interface my_wwan ipv4 surelink)> attempts num
(config network interface my_wwan ipv4 surelink>
The default is 3.
g. Set the amount of time that the device should wait for a response to a probe attempt
before considering it to have failed:
(config network interface my_wwan ipv4 surelink)> timeout value
(config network interface my_wwan ipv4 surelink>
The default is 15 seconds.
8. (Optional) Repeat this procedure for IPv6.
IX10 User Guide
Wireless Wide Area Networks (WWANs)
46