Digi IX10 User Manual page 310

Services
5. (Optional) Add upstream NTP servers that the device will use to synchronize its time. The
default setting is time.devicecloud.com.
To change the default value of the NTP server:
n
a. Click NTP servers.
b. For Server, type a new server name.
To add an NTP server:
n
a. Click NTP servers.
b. For Add Server, click .
c. For Server, enter the hostname of the upstream NTP server that the device will use
d. Click  to add additional NTP servers. If multiple servers are included, servers are
Note This list is synchronized with the list of servers included with NTP server configuration,
and changes made to one will be reflected in the other. See
server for more information about NTP server configuration.
6. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX10 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) Set the timezone for the location of your IX10 device. The default is UTC.
(config)> system time timezone value
(config)>
Where value is the timezone using the format specified with the following command:
(config)> system time timezone ?
Timezone: The timezone for the location of this device. This is used to
adjust the time for log
messages. It also affects actions that occur at a specific time of day.
Format:
Africa/Abidjan
IX10 User Guide
to synchronize its time.
tried in the order listed until one succeeds.
Configure the system time
Configure the device as an NTP
310