Digi IX10 User Manual page 474

System administration
c. Reset the default password for the admin account. See
the admin user

Command line
1. Log into the IX10 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the following:
> system factory-erase
3. After resetting the device:
a. Connect to the IX10 by using the serial port or by using an Ethernet cable to connect the
IX10 ETH port to your PC.
b. Log into the IX10:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
When you first log into the WebUI or the command line, you must change the password for
the admin user. See
c. Reset the default password for the admin account. See
the admin user
Reset the device by using the ERASE button.
1. Locate the ERASE button on your device.
2. Press and hold the ERASE button perform a device reset. The ERASE button has modes:
Configuration reset:
n
l
Full device reset:
n
l
l
3. After resetting the device:
a. Connect to the IX10 by using the serial port or by using an Ethernet cable to connect the
IX10 ETH port to your PC.
b. Log into the IX10:
User name: Use the default user name: admin.
Password: Use the unique password printed on the bottom label of the device (or the
printed label included in the package).
When you first log into the WebUI or the command line, you must change the password for
the admin user. See
IX10 User Guide
for further information.
Change the default password for the admin user
for further information.
The device reboots automatically and resets to factory defaults. This does not
remove any automatically generated certificates and keys.
After the device reboots from the first button press, immediately press and the
ERASE button again.
The device reboots again and resets to factory defaults, as well as also removing
generated certificates and keys.
Change the default password for the admin user
Reset the device to factory defaults
Change the default password for
for instructions.
Change the default password for
for instructions.
474