Task Two: Configure The Application To Run Automatically - Digi IX10 User Manual

Applications

Task two: Configure the application to run automatically

Note This feature does not provide syntax or error checking. Certain commands can render the device
inoperable. Use with care.

WebUI
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click System > Scheduled tasks > Custom scripts.
4. For Add Script, click .
The schedule script configuration window is displayed.
Scheduled scripts are enabled by default. To disable, click Enable to toggle off.
5. (Optional) For Label, provide a label for the script.
6. For Run mode, select the mode that will be used to run the script. Available options are:
On boot: The script will run once each time the device boots.
n
l
Interval: The script will start running at the specified interval, within 30 seconds after
n
the configuration change is saved.
IX10 User Guide
If On boot is selected, select the action that will be taken when the script
completes in Exit action. Available options are:
None: Action taken when the script exits.
o
Restart script: Runs the script repeatedly.
o
Reboot: The device will reboot when the script completes.
o
Configure applications to run automatically
333