Digi IX10 User Manual page 227

Virtual Private Networks (VPN)
n
12. Save the configuration and apply the change:
(config openvpn client openvpn_client1 connection_monitor target 0)> save
Configuration saved.
>
13. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX10 User Guide
interface_up (IPv4) or interface_up6 (IPv6): : The interface is considered to be
down based on the interfaces down time, and the amount of time an initial
connection to the interface takes before this test is considered to have failed.
(Optional) Set the amount of time that the interface can be down before this
l
test is considered to have failed:
(config vpn openvpn client openvpn_client1 connection_monitor
target 0)> interface_down_time value
(config vpn openvpn client openvpn_client1 connection_monitor
target 0)>
where value is any number of weeks, days, hours, minutes, or seconds, and
takes the format number{w|d|h|m|s}.
For example, to set interface_down_time to ten minutes, enter either 10m or
600s:
(config openvpn client openvpn_client1 connection_monitor
target 0)> interface_down_time 600s
(config openvpn client openvpn_client1 connection_monitor
target 0)>
The default is 60 seconds.
(Optional) Set the amount of time to wait for an initial connection to the
l
interface before this test is considered to have failed:
(config vpn openvpn client openvpn_client1 connection_monitor
target 0)> interface_timeout value
(config vpn openvpn client openvpn_client1 connection_monitor
target 0)>
where value is any number of weeks, days, hours, minutes, or seconds, and
takes the format number{w|d|h|m|s}.
For example, to set interface_timeout to ten minutes, enter either 10m or
600s:
(config network interface my_wwan ipv4 connection_monitor
target 0)> interface_timeout 600s
(config network interface my_wwan ipv4 connection_monitor
target 0)>
The default is 60 seconds.
OpenVPN
227