Digi IX10 User Manual page 380

User authentication
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > Groups.
4. For Add, type a name for the group and click .
The group configuration window is displayed.
5. Click the following options, as appropriate, to enable or disable access rights for each:
Admin access
n
For groups assigned Admin access, you can also determine whether the Access level
should be Full access or Read-only access.
where value is either:
l
l
The default is Full access full.
Shell access
n
Shell access is not available if the Allow shell parameter has been disabled. See
shell access
Serial access
n
6. (Optional) Configure OpenVPN access. See for further information.
7. (Optional) Configure captive portal access:
IX10 User Guide
Full access full: provides users of this group with the ability to manage the IX10
device by using the WebUI or the Admin CLI.
Read-only access read-only: provides users of this group with read-only access to
the WebUI and Admin CLI.
for more information about the Allow shell parameter.
Authentication groups
Disable
380