Configuration Methods; Using Digi Remote Manager - Digi IX10 User Manual

Configuration and management
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configuration methods

There are two primary methods for configuring your IX10 device:
Web interface.
n
The web interface can be accessed in two ways:
Central management using the Digi Remote Manager, a cloud-based device management
l
and data enablement platform that allows you to connect any device to any application,
anywhere. With the Remote Manager, you can configure your IX10 device and use the
configuration as a basis for a profile which can be applied to other similar devices. See

Using Digi Remote Manager

manage and configure your IX10 device.
The local web interface. See
l
local web interface to manage and configure your IX10 device.
Web-based instructions in this guide are applicable to both the Remote Manager and the local
web interface.
Command line.
n
A robust command line allows you to perform all configuration and management tasks from
within a command shell. Both the Remote Manager and the local web interface also have the
option to open a terminal emulator for executing commands on your IX10 device. See
command line
your IX10 device.
In this guide, task topics show how to perform tasks:

WebUI
Shows how to perform a task by using the local web interface.

Command line
Shows how to perform a task by using the command line interface.
Using Digi Remote Manager
By default, your IX10 device is configured to use Digi Remote Manager as its central management
server. No configuration changes are required to begin using the Remote Manager.
For information about configuring central management for your IX10 device, see
.
IX10 User Guide
for more information about using the Remote Manager to
Using the web interface
for more information about using the command line to manage and configure
Configuration methods
for more information about using the
Central management
Using the
35