Digi IX10 User Manual page 49

Interfaces
Test the interface status: The interface is considered to be down based on:
n
l
l
11. Optional active recovery configuration parameters:
a. Change the Interval between connectivity tests.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Interval to ten minutes, enter 10m or 600s.
The default is 15 minutes.
b. If more than one test target is configured, for Success condition, determine whether the
interface should fail over based on the failure of one of the test targets, or all of the test
targets.
c. For Attempts, type the number of probe attempts before the WAN is considered to have
failed.
d. For Response timeout, type the amount of time that the device should wait for a
response to a probe attempt before considering it to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Response timeout to ten minutes, enter 10m or 600s.
The default is 15 seconds.
12. (Optional) Repeat this procedure for IPv6.
13. Click Apply to save the configuration and apply the change.

Command line
Active recovery can be configured for both IPv4 and IPv6. These instructions are for IPv4; to configure
IPv6 active recovery, replace ipv4 in the command line with ipv6.
IX10 User Guide
Down time: The amount of time that the interface can be down before this test is
considered to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take
the format number{w|d|h|m|s}.
For example, to set Down time to ten minutes, enter 10m or 600s.
The default is 60 seconds.
Initial connection time: The amount of time to wait for an initial connection to the
interface before this test is considered to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take
the format number{w|d|h|m|s}.
For example, to set Initial connection time to ten minutes, enter 10m or 600s.
The default is 60 seconds.
Wireless Wide Area Networks (WWANs)
49