Digi IX10 User Manual page 213

Virtual Private Networks (VPN)

Command line
1. Log into the IX10 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Use the add auth group command to add a new authentication. For example, to add a group
named OpenVPN_Group:
(config)> add auth group OpenVPN_Group
(config auth group OpenVPN_Group)>
4. Enable OpenVPN access rights for users of this group:
(config auth group OpenVPN_Group)> acl openvpn enable true
5. Add an OpenVPN tunnel to which users of this group will have access:
a. Determine available tunnels:
(config auth group OpenVPN_Group)> .. .. .. vpn openvpn server ?
Servers: A list of openvpn servers
Additional Configuration
-----------------------------------------------------------------------
--------
OpenVPN_server1
(config auth group OpenVPN_Group)>
b. Add a tunnel:
(config auth group OpenVPN_Group)> add auth group test acl openvpn
tunnels end /vpn/openvpn/server/OpenVPN_server1
(config auth group OpenVPN_Group)>
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
IX10 User Guide
OpenVPN server
OpenVPN
213