Step 3: Connect - Digi IX10 User Manual

Digi IX10 Quick start

Step 3: Connect

1. Insert SIM card(s)
Insert your activated SIM (2FF) card(s) provided by your cellular carrier into the device:
a. Use a screw driver to remove the SIM slot cover.
b. For high-vibration environments, apply a thin layer of dielectric grease to the SIM contacts.
Note
contact fretting may cause unexpected SIM card failures. To protect the SIM cards, Digi
strongly recommends that you apply a thin layer of dielectric grease to the SIM contacts
prior to installing the SIM cards.
IX10 User Guide
SIM card(s)
If you intend to configure cellular WWAN access at this time, acquire SIM
cards as needed. Note the carrier, network APN (Access Point Name),
and SIM pin (if any) for each card.
Ethernet cable
Smart phone or tablet
Optional: Use a smart phone or table to to automatically register your
IX10 in your Digi Remote Manager account and connect to your cellular
network. See
If the IX10 device is used in an environment with high vibration levels, SIM card
Quick start using the Digi Remote Manager mobile
Step 3: Connect
app.
17