Show Modbus Gateway Status And Statistics - Digi IX10 User Manual

Services
i. Repeat the above instructions for additional clients.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show Modbus gateway status and statistics

You can view status and statistics about location information from either the WebUI or the command
line.

WebUI
1. Log into the IX10 WebUI as a user with Admin access.
2. On the menu, select Status > Modbus Gateway.
The Modbus Gateway page appears.
Statistics related to the Modbus gateway server are displayed. If the message Server
connections not available is displayed, this indicates that there are no connected clients.
To view information about Modbus gateway clients, click Clients.
n
To view statistics that are common to both the clients and server, click Common
n
Statistics.
To view configuration details about the gateway, click the  (configuration) icon in the
n
upper right of the gateway's status pane.

Command line
1. Log into the IX10 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Use the show modbus-gateway
> show modbus-gateway
Server Connection
-----------------
modbus_socket
modbus_socket
Client
--------------------
modbus_socket_41
IX10 User Guide
This will configure the gateway to deliver all messages that have the Modbus server
address address of 20 to the device with address 10.
command at the system prompt:
IP Address
-----------
10.45.1.139
10.45.1.139
Uptime
------
0
Port Uptime
----- ------
49570 6
49568 13
Modbus gateway
306