Reset The Device To Factory Defaults - Digi IX10 User Manual

System administration
3. Select System > Scheduled tasks.
4. For Reboot time, enter the time of the day that the device should reboot, using the format
HH:MM. The device will reboot at this time every day.
If a value is set for Reboot time but the device is unable to synchronize its time with an NTP
server, the device will reboot after it has been up for 24 hours. See
about configuring NTP servers.
5. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX10 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set the reboot time:
(config>> system schedule reboot_time time
(config)>
where time is the time of the day that the device should reboot, using the format HH:MM. For
example, the set the device to reboot at two in the morning every day:
(config>> system schedule reboot_time 02:00
(config)>
If a value is set for reboot_time but the device is unable to synchronize its time with an NTP
server, the device will reboot after it has been up for 24 hours. See
about configuring NTP servers.
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Reset the device to factory defaults

Resetting the device to factory defaults performs the following actions:
IX10 User Guide
Reset the device to factory defaults
System time for information
System time for information
472