Digi IX10 User Manual page 58

Interfaces
10. For Access technology, select the type of cellular technology that this modem should use to
access the cellular network, or select All technologies to configure the modem to use the best
available technology. The default is All technologies.
11. For Antennas, select whether the modem should use the main antenna, the auxiliary antenna,
or both the main and auxiliary antennas.
12. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX10 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Modem configurations are enabled by default. To disable:
(config)> network modem modem enable false
(config)>
4. Set the matching criteria used to determine if this modem configuration applies to the
currently attached modem:
(config)> network modem modem match value
(config)>
where value is one of the following:
any: Applies this configuration to any modem that is attached.
n
imei: Applies this configuration only to a modem that matches the identified IMEI.
n
l
port: Applies this configuration to a modem attached to the identified physical port.
n
l
IX10 User Guide
If imei is used, set the IMEI of the modem that this configuration should be applied
to:
(config)> network modem modem imei value
(config)>
where value is the IMEI of the modem.
If port is used, set modem's port:
a. Determine available ports and correct syntax by using the ?:
(config)> network modem modem port ?
Wireless Wide Area Networks (WWANs)
58