Create A Virtual Lan (Vlan) Route - Digi IX10 User Manual

Interfaces
1. Log into the IX10 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show dhcp-lease
> show dhcp-lease
IP Address
-------------
192.168.2.194
192.168.2.195
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Create a Virtual LAN (VLAN) route

Virtual LANs (VLANs) allow splitting a single physical LAN into separate Virtual LANs. This is useful for
security reasons, and also helps to reduce broadcast traffic on the LAN.
Required configuration items
Device to be assigned to the VLAN.
n
The VLAN ID. The TCP header uses the VLAN ID to identify the destination VLAN for the packet.
n
To create a VLAN:

WebUI
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Virtual LAN.
4. Type a name for the VLAN and click .
5. Select the Device.
6. Type or select a unique numeric ID for the VLAN ID.
IX10 User Guide
command at the Admn CLI prompt:
Hostname Expires
--------------- -------
MTK-ENG-USER1
MTK-ENG-USER2
Local Area Networks (LANs)
106