Digi IX10 User Manual page 436

Firewall
Port forwarding rules are enabled by default. To disable, click to toggle off Enable.
5. (Optional) Type a Label that will be used to identify the rule.
6. For Interface, select the network interface for the rule.
Network connections will only be forwarded if their destination address matches the IP
address of the selected network interface.
7. For IP version, select either IPv4 or IPv6.
Network connections will only be forwarded if they match the selected IP version.
8. For Protocol, select the type of internet protocol.
Network connections will only be forwarded if they match the selected protocol.
9. For Port, type the public-facing port number that network connections must use for their
traffic to be forwarded.
10. For To Address, type the IP address of the server to which traffic should be forwarded.
11. For To port, type the port number of the port on the server to which traffic should be
forwarded.
12. (Optional) Click Access control list to create a white list of devices that are authorized to
leverage this forwarding rule, based on either the IP address or firewall zone:
To white list IP addresses:
n
a. Click Addresses.
b. For Add Address, enter an IP address and click .
c. Repeat for each additional IP address that should be white listed.
To specify firewall zones for white listing:
n
a. Click Zones.
b. For Add zone, click .
c. For Zone, select the appropriate zone.
d. Repeat for each additional zone.
13. Click Apply to save the configuration and apply the change.

Command line
IX10 User Guide
Port forwarding rules
436