Digi IX10 User Manual page 222

Virtual Private Networks (VPN)
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click VPN > OpenVPN > Clients.
4. Create a new OpenVPN client or select an existing one:
To create a new OpenVPN client, see
n
or Configure an OpenVPN client without using an .ovpn
To edit an existing OpenVPN client, click to expand the appropriate client.
n
5. After creating or selecting the OpenVPN client, click Active recovery.
6. Enable active recovery.
7. For Restart interface, enable to configure the device to restart the interface when its
connection is considered to have failed. This is useful for interfaces that may regain
connectivity after restarting, such as a cellular modem.
8. For Reboot device, enable to instruct the device to reboot when the WAN connection is
considered to have failed.
9. Change the Interval between connectivity tests.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Interval to ten minutes, enter 10m or 600s.
The default is 15 minutes.
10. For Success condition, determine whether the interface should fail over based on the failure
of one of the test targets, or all of the test targets.
IX10 User Guide
Configure an OpenVPN client by using an .ovpn file
file.
OpenVPN
222