Dhcp Servers - Digi IX10 User Manual

Interfaces
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Click the menu icon (...) next to the name of the LAN to be deleted and select Delete.
5. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX10 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Use the del command to delete the LAN. For example, to delete a LAN named my_lan:
(config)> del network interface my_lan
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

DHCP servers

You can enable DHCP on your IX10 device to assign IP addresses to clients, using either:
The DHCP server for the device's local network, which assigns IP addresses to clients on the
n
device's local network. Addresses are assigned from a specified pool of IP addresses. For a
IX10 User Guide
Local Area Networks (LANs)
91