Show Wwan Status And Statistics - Digi IX10 User Manual

Interfaces
a. Click IPv6 to expand.
b. IPv6 support is enabled by default. To disable:
(config network interface my_wwan)> ipv6 enable false
(config network interface my_wwan)>
c. Set the MTU.
(config network interface my_wwan)> ipv6 mtu num
(config network interface my_wwan)>
d. See Configure SureLink active recovery to detect modem failures
configuring active recovery.
1. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
2. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Show WWAN status and statistics


WebUI
1. Log into the IX10 WebUI as a user with Admin access.
2. From the menu, click Status.
3. Under Networking, click Interfaces.

Command line
1. Log into the IX10 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show network
> show network
Interface
----------------
defaultip
defaultlinklocal
eth1
eth1
eth
eth
loopback
IX10 User Guide
command at the Admin CLI prompt:
Proto Status Address
----- ------- -------------------------------
IPv4 up 192.168.210.1/24
IPv4 up 169.254.100.100/16
IPv4 up 10.10.10.10/24
IPv6 up fe00:2404::240:f4ff:fe80:120/64
IPv4 up 192.168.2.1/24
IPv6 up fd00:2704::1/48
IPv4 up 127.0.0.1/8
Wireless Wide Area Networks (WWANs)
for information about
80