Digi IX10 User Manual page 140

Routing
3. Click Network > Dynamic DNS.
4. Type a name for this Dynamic DNS instance in Add Service and click .
The Dynamic DNS configuration page displays.
New Dynamic DNS configurations are enabled by default. To disable, click to toggle Enable to
off.
5. For Interface, select the interface that has its IP address registered with the Dynamic DNS
provider.
6. For Service, select the Dynamic DNS provider, or select custom to enter a custom URL for the
Dynamic DNS provider.
7. If custom is selected for Service, type the Custom URL that should be used to update the IP
address with the Dynamic DNS provider.
8. Type the Domain name that is linked to the interface's IP address.
9. Type the Username and Password used to authenticate with the Dynamic DNS provider.
10. (Optional) For Check Interval, type the amount of time to wait to check if the interface's IP
address needs to be updated.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Check interval to ten minutes, enter 10m or 600s.
11. (Optional) For Forced update interval, type the amount of time to wait to force an update of
the interface's IP address.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and take the
format number{w|d|h|m|s}.
For example, to set Forced update interval to ten minutes, enter 10m or 600s.
The setting for Forced update interval must be larger than the setting for Check Interval.
IX10 User Guide
Dynamic DNS
140