Digi IX10 User Manual page 508

Central management
3. Click Central management.
The Central management configuration window is displayed.
Digi Remote Manager support is enabled by default. To disable, click Enable central
management.
4. (Optional) For Service, select either Digi Remote Manager or Digi aView. The default is Digi
Remote Manager.
5. (Optional) For Management server, type the URL for the central management server. The
default is the Digi Remote Manager server, my.devicecloud.com.
6. (Optional) For Management port, type the destination port for the remote cloud services
connection. The default is 3199.
7. (Optional) For Retry interval, type the amount of time that the IX10 device should wait before
reattempting to connect to remote cloud services after being disconnected. The default is 30
seconds.
Allowed values are any number of hours, minutes, or seconds, and take the format number
{h|m|s}.
For example, to set Retry interval to ten minutes, enter 10m or 600s.
8. (Optional) For Keep-alive interval, type the amount of time that the IX10 device should wait
between sending keep-alive messages to remote cloud services when using a non-cellular
interface. The default is 60 seconds.
Allowed values are any number of hours, minutes, or seconds, and take the format number
{h|m|s}.
For example, to set Keep-alive interval to ten minutes, enter 10m or 600s.
9. (Optional) For Cellular keep-alive interval, type the amount of time that the IX10 device
should wait between sending keep-alive messages to remote cloud services when using a
cellular interface. The default is 290 seconds.
Allowed values are any number of hours, minutes, or seconds, and take the format number
{h|m|s}.
For example, to set Cellular keep-alive interval to ten minutes, enter 10m or 600s.
10. (Optional) For Allowed keep-alive misses, type the number of allowed keep-alive misses. The
default is 3.
11. Enable watchdog is used to monitor the connection to remote cloud services. If the
connection is down, you can configure the device to restart the connection, or to reboot. The
watchdog is enabled by default.
IX10 User Guide
Configure Digi Remote Manager
508