Digi IX10 User Manual page 261

Services
Enable or disable the web administration service
The web administration service is enabled by default. To disable the service, or enable it if it has been
disabled:

WebUI
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Web administration.
4. Click Enable.
5. Click Apply to save the configuration and apply the change.

Command line
1. Log into the IX10 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable the web administration service:
To enable the service:
n
(config)> service web_admin enable true
(config)>
To disable the sevice:
n
(config)> service web_admin enable false
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
IX10 User Guide
Configure the web administration service
261