Show Vrrp Status And Statistics - Digi IX10 User Manual

Routing

Show VRRP status and statistics

This section describes how to display VRRP status and statistics for a IX10 device. VRRP status is
available from the Web UI only.

WebUI
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Status > VRRP.
The Virtual Router Redundancy Protocol window is displayed.

Command line
1. Log into the IX10 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type
> show vrrp
VRRP
----
VRRP_test
VRRP_test
>
3. To display additional information about a specific VRRP instance, at the Admin CLI prompt, type
show vrrp name
> show vrrp name VRRP_test
VRRP_test VRRP Status
---------------------
IX10 User Guide
show vrrp:
Status Proto State
------ ----- ------
Up IPv4 Backup
Up IPv4 Backup
name:
Virtual Router Redundancy Protocol (VRRP)
Virtual IP
-------------
10.10.10.1
100.100.100.1
164