Configure A Wireless Wide Area Network (Wwan) - Digi IX10 User Manual

Interfaces
d. Configure the source address:
i. Set the source type to address:
(config network route policy 0)> src type address
(config network route policy 0)>
ii. Set the IP address to 192.168.2.101:
(config network route policy 0)> src address 192.168.2.101
(config network route policy 0)>
e. Configure the destination address:
i. Set the type to interface:
(config network route policy 1)> dst type interface
(config network route policy 1)>
ii. Set the interface to WWANPrivate :
(config network route policy 1)> interface
/network/interface/WWANPrivate
(config network route policy 1)>
6. Save the configuration and apply the change:
(config network route policy 1)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a Wireless Wide Area Network (WWAN)

Configuring a Wireless Wide Area Network (WWAN) involves configuring the following items:
Required configuration items
The interface type: Modem.
n
The firewall zone: External.
n
The cellular modem that is used by the WWAN.
n
Additional configuration items
SIM selection for this WWAN.
n
The SIM PIN.
n
The SIM phone number for SMS connections.
n
Enable or disable roaming.
n
DNS options.
n
SIM failover configuration.
n
IX10 User Guide
Wireless Wide Area Networks (WWANs)
72