Digi IX10 User Manual page 137

Routing
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable routing services:
(config)> network route service enable true
(config)>
4. Configure routing services that will be used:
a. Use the ? to display available routing services:
(config)> network route service ?
Routing services: Settings for dynamic routing services and protocols.
Parameters
-----------------------------------------------------------------------
--------
enable
zone
Additional Configuration
-----------------------------------------------------------------------
--------
babel
bgp
isis
ospfv2
ospfv3
rip
ripng
(config)>
b. Enable a routing service that will be used. For example, to enable the RIP service:
(config)> network route service rip enable true
(config)>
c. Complete the configuration of the routing service. For example, use the ? to view the
available parameters for the RIP service:
(config)> network route service rip ?
Parameters
-----------------------------------------------------------------------
--------
ecmp
enable
IX10 User Guide
Current Value
true Enable
dynamic_routes Zone
Babel
BGP
IS-IS
OSPFv2
OSPFv3
RIP
RIPng
Current Value
false Allow ECMP
true Enable
IP routing
137