Disable Surelink - Digi IX10 User Manual

Interfaces
b. Set the Interval between connectivity tests:
(config network interface my_wwan ipv4 surelink)> interval value
(config network interface my_wwan ipv4 surelink>
The default is 15 minutes.
c. If more than one test target is configured, determine whether the interface should fail
over based on the failure of one of the test targets, or all of the test targets:
(config network interface my_wwan ipv4 surelink)> success_condition
value
(config network interface my_wwan ipv4 surelink>
Where value is either one or all.
d. Set the number of probe attempts before the WAN is considered to have failed:
(config network interface my_wwan ipv4 surelink)> attempts num
(config network interface my_wwan ipv4 surelink>
The default is 3.
e. Set the amount of time that the device should wait for a response to a probe attempt
before considering it to have failed:
(config network interface my_wwan ipv4 surelink)> timeout value
(config network interface my_wwan ipv4 surelink>
The default is 15 seconds.
9. (Optional) Repeat this procedure for IPv6.
10. Save the configuration and apply the change:
(config network interface my_wwan ipv4 surelink)> save
Configuration saved.
>
11. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Disable SureLink

If your device uses a private APN with no Internet access, or your device has a restricted wired WAN
connection that doesn't allow DNS resolution, follow this procedure to disable the default SureLink
connectivity tests. You can also disable DNS lookup or other internet activity, while retaining the
SureLink interface test.

WebUI
IX10 User Guide
Wireless Wide Area Networks (WWANs)
52