Delete A Port Forwarding Rule - Digi IX10 User Manual

Firewall
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config firewall dnat 0 acl)>
11. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Delete a port forwarding rule

To delete a port forwarding rule:

WebUI
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Firewall > Port forwarding.
4. Click the menu icon (...) next to the appropriate port forwarding rule and select Delete.
5. Click Apply to save the configuration and apply the change.

Command line
IX10 User Guide
Port forwarding rules
439