Digi IX10 User Manual page 73

Interfaces
APN configuration.
n
The custom gateway/netmask.
n
IPv4 configuration:
n
The metric for IPv4 routes associated with the WAN.
l
The relative weight for IPv4 routes associated with the WAN.
l
The IPv4 management priority of the WAN. The active interface with the highest
l
management priority will have its address reported as the preferred contact address for
central management and direct device access.
The IPv4 Maximum Transmission Unit (MTU) of the WAN.
l
SureLink active recovery configuration. See
l
modem failures
IPv6 configuration:
n
The metric for IPv6 routes associated with the WAN.
l
The relative weight for IPv6 routes associated with the WAN.
l
The IPv6 management priority of the WAN. The active interface with the highest
l
management priority will have its address reported as the preferred contact address for
central management and direct device access.
The IPv6 Maximum Transmission Unit (MTU) of the WAN.
l
SureLink active recovery configuration. See
l
modem failures

WebUI
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Create the WWAN or select an existing WWAN:
To create a new WWAN, for Add interface, type a name for the WWAN and click .
n
To edit an existing WWAN, click to expand the WWAN.
n
New WWANs are enabled by default. To disable, click Enable.
IX10 User Guide
for further information.
for further information.
Wireless Wide Area Networks (WWANs)
Configure SureLink active recovery to detect
Configure SureLink active recovery to detect
73