Digi IX10 User Manual page 485

System administration
c. Configure the frequency that the maintenance tasks should be run:
system schedule maintenance frequency value
(config)>
where value is either daily or weekly. Daily is the default.
d. Configure the device to look for any updated modem firmware during the maintenance
window. If updated firmware is found, it will then be installed. The device will look for
updated firmware both on the local device and over the network, using either a WAN or
cellular connection.
system schedule maintenance modem_fw_update value
(config)>
where value is either true or false. yes or no, and 1 or 0 are also allowed.
e. Allow for the configuration to be updated, including by custom scripts, during the
maintenance window:
system schedule maintenance config_check value
(config)>
where value is either true or false. yes or no, and 1 or 0 are also allowed.
4. (Optional) Schedule custom scripts:
a. Add a script:
(config)> add system schedule script end
(config system schedule script 0)>
Scheduled scripts are enabled by default. To disable:
(config system schedule script 0)> enable false
(config system schedule script 0)>
b. (Optional) Provide a label for the script.
(config system schedule script 0)> label value
(config system schedule script 0)>
where value is any string. if spaces are used, enclose value within double quotes.
c. Set the mode that will be used to run the script:
(config system schedule script 0)> when mode
(config system schedule script 0)>
where mode is one of the following:
n
IX10 User Guide
boot: The script will run once each time the device boots.
If boot is selected, set the action that will be taken when the script completes:
l
(config system schedule script 0)> exit_action action
(config system schedule script 0)>
where action is one of the following:
Schedule system maintenance tasks
485