Disable Device Encryption - Digi IX10 User Manual

System administration
e. Script logging options:
n
n
If syslog_stdout and syslog_stderr are not enabled, only the script's exit code is written
to the system log.
f. Set the maximum amount of memory available to be used by the script and its
subprocesses:
(config system schedule script 0)> max_memory value
(config system schedule script 0)>
where value uses the syntax number{b|bytes|KB|k|MB|MB|M|GB|G|TB|T}.
g. To run the script only once at the specified time:
(config system schedule script 0)> once true
(config system schedule script 0)>
If once is enabled, rebooting the device will cause the script to run again. The only way to
re-run the script is to:
n
n
n
h. Sandbox is enabled by default. This option protects the script from accidentally destroying
the system it is running on.
(config system schedule script 0)> sandbox true
(config system schedule script 0)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Disable device encryption

You can disable the cryptography on your IX10 device. This can be used to ship unused devices from
overseas without needing export licenses from the country from which the device is being shipped.
When device encryption is disabled, the following occurs:
IX10 User Guide
To log the script's output to the system log:
(config system schedule script 0)> syslog_stdout true
(config system schedule script 0)>
To log script errors to the system log:
(config system schedule script 0)> syslog_stderr true
(config system schedule script 0)>
Remove the script from the device and add it again.
Make a change to the script.
Disable once.
Disable device encryption
487