Configure Ssh Access - Digi IX10 User Manual

Services
Configure SSH access
The IX10's default configuration has SSH access enabled, and allows SSH access to the device from
authorized users within the Internal firewall zone. If this configuration is sufficient for your needs, no
further configuration is required. See
information about configuring the SSH service to allow access from remote devices.
Required configuration items
Enable SSH access.
n
Configure access control for the SSH service.
n
Additional configuration items
Port to use for communications with the SSH service.
n
Multicast DNS (mDNS) support.
n
A private key to use for communications with the SSH service.
n
See Set the idle timeout for IX10 users
service.
Enable or disable the SSH service
The SSH service is enabled by default. To disable the service, or enable it if it has been disabled:

WebUI
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > SSH.
4. Click Enable.
5. Click Apply to save the configuration and apply the change.

Command line
IX10 User Guide
Allow remote access for web administration and SSH
for information about setting the inactivity timeout for the SSH
Configure SSH access
for
269