Digi IX10 User Manual page 486

System administration
n
n
n
d. Set the commands that will execute the script:
(config system schedule script 0)> commands filename
(config system schedule script 0)>
where filename is the path and filename of the script, and any related command line
information.
If the script begins with #!, then the script will be invoked in the location specified by the
path for the script command. Otherwise, the default shell will be used (equivalent to
#!/bin/sh).
IX10 User Guide
none: Action taken when the script exits.
o
restart: Runs the script repeatedly.
o
reboot: The device will reboot when the script completes.
o
interval: The script will start running at the specified interval, within 30 seconds
after the configuration change is saved. If interval is selected:
Set the interval:
l
(config system schedule script 0)> on_interval value
(config system schedule script 0)>
where value is any number of weeks, days, hours, minutes, or seconds, and
takes the format number{w|d|h|m|s}.
For example, to set on_interval to ten minutes, enter either 10m or 600s:
(config system schedule script 0)> on_interval
(config system schedule script 0)>
(Optional) Configure the script to run only a single instance at a time:
l
(config system schedule script 0)> once true
(config system schedule script 0)>
If once is set to false, a new instance of the script will be started at every
interval, regardless of whether the script is still running from a previous
interval.
set_time: Runs the script at a specified time of the day.
If set_time is set, set the time that the script should run, using the format
l
HH:MM:
(config system schedule script 0)> run_time HH:MM
(config system schedule script 0)>
maintenance_time: The script will run during the system maintenance time
window.
Schedule system maintenance tasks
600s
486