Digi IX10 User Manual page 57

Interfaces

WebUI
1. Log into the IX10 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Modems > Modem.
4. Modem are enabled by default. Click to toggle Enable to off to disable.
5. For Match modem by, select the matching criteria used to determine if this modem
configuration applies to the currently attached modem:
Any modem: Applies this configuration to any modem that is attached.
n
IMEI: Applies this configuration only to a modem that matches the identified IMEI.
n
l
Port: Applies this configuration to a modem attached to the identified physical port.
n
l
The default is Any modem.
6. For Active SIM slot, select the SIM slot that should be used by the modem, or select Any to
use any SIM slot. The default is Any.
7. If Active SIM slot is set to Any, for Preferred SIM slot, select the SIM slot that should be
considered the preferred slot for this modem, or select None. In the event of a failover to a
non-preferred SIM, or if manual SIM switching is used to switch to a non-preferred SIM, the
modem will attempt to reconnect to the SIM in the preferred SIM slot. None is the default.
8. For Maximum number of interfaces, type the number of interfaces that can be configured to
use this modem. This is used when using
9. Enable Carrier switching to allow the modem to automatically match the carrier for the active
SIM. Carrier switching is enabled by default.
IX10 User Guide
If IMEI is selected, for Match IMEI, type the IMEI of the modem that this
configuration should be applied to.
If Port is selected, for Match Port, select the modem's port.
Wireless Wide Area Networks (WWANs)
dual-APN SIMs. The default is 1.
57