Digi IX10 User Manual page 407

User authentication
4. Add RADIUS servers:
a. For Add server, click .
b. For Hostname, type the hostname or IP address of the RADIUS server.
c. (Optional) Change the default Port setting to the appropriate port. Normally this should be
left at the default setting of port 1812.
d. For Secret, type the RADIUS server's shared secret. This is configured in the secret
parameter of the RADIUS server's client.conf file, for example:
secret=testing123
e. For Timeout, type or select the amount of time in seconds to wait for the RADIUS server to
respond. Allowed value is any integer from 3 to 60. The default value is 3.
f. (Optional) Click  again to add additional RADIUS servers.
5. (Optional) Enable Authoritative to prevent other authentication methods from being used if
RADIUS authentication fails. Other authentication methods will only be used if the RADIUS
server is unavailable.
6. (Optional) Click RADIUS debug to enable additional debug messages from the RADIUS client.
7. (Optional) For NAS ID, type the unique identifier for this network access server (NAS). You can
use the fully-qualified domain name of the NAS or any arbitrary string. If not set, the default
value is used:
If you are accessing the IX10 device by using the WebUI, the default value is for NAS ID is
n
httpd.
If you are accessing the IX10 device by using ssh, the default value is sshd.
n
8. Add RADIUS to the authentication methods:
a. Click Authentication > Methods.
b. For Add method, click .
IX10 User Guide
Remote Authentication Dial-In User Service (RADIUS)
407