Digi IX10 User Manual page 427

User authentication
n
c. Save and close the tac_plus.conf file.
3. Log into the IX10 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
4. At the command line, type config to enter configuration mode:
> config
(config)>
5. Configure the authentication methods:
a. Determine the current authentication method configuration:
(config)> show auth method
0 local
(config)>
This output indicates that on this example system, only local authentication is configured.
b. Add RADIUS authentication to the beginning of the list:
(config)> add auth method 0 radius
(config)>
c. Add TACACS+ authentication second place in the list:
(config)> add auth method 1 tacacs+(config)>
d. Verify that authentication will occur in the correct order:
(config)> show auth method
0 radius
1 tacacs+
2 local
(config)>
6. Verify that the admin group has full administrator rights:
(config)> show auth group admin acl
admin
enable true
level full
...
(config)>
If admin > enable is set to false:
(config)> auth group admin acl admin enable true
(config)>
IX10 User Guide
The authentication group on the IX10 device, admin, is identified in the groupname
parameter.
Example user configuration
427