Digi IX10 User Manual page 134

Routing
(config network route policy 0)> src mac MAC_address
(config network route policy 0)>
10. Set the destination address type:
(config network route policy 0)> dst type value
(config network route policy 0)>
where value is one of:
zone: Matches the destination IP address to the selected firewall zone. Set the zone:
n
a. Use the ? to determine available zones:
b. Set the zone. For example:
See
interface: Matches the destination IP address to the selected interface's network
n
address. Set the interface:
a. Use the ? to determine available interfaces:
b. Set the interface. For example:
address: Matches the destination IPv4 address to the specified IP address or network.
n
Set the address that will be matched:
(config network route policy 0)> dst address value
(config network route policy 0)>
IX10 User Guide
(config network route policy 0)> dst zone ?
Zone: Match the IP address to the specified firewall zone.
Format:
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
Default value: any
Current value: any
(config network route policy 0)> dst zone
(config network route policy 0)> dst zone external
(config network route policy 0)>
Firewall configuration for more information about firewall zones.
(config network route policy 0)> dst interface
/network/interface/eth1
(config network route policy 0)>
IP routing
134